Carel Ritcusrg02 Manual [PRO • 2024]

Supports standard Carel NTC (10 kΩ at 25 °C) and PTC (985 Ω at 25 °C) probes.

If prompted for a password (), the default is typically 22 for configuration access.

Below is a guide to its primary functions, installation requirements, and programming steps based on official Carel documentation. carel ritcusrg02 manual

If the compressor or fan icons are blinking, it typically indicates a delay (e.g., minimum off-time) is active before the device will start. 4. Programming Parameters

After modifying values with the arrows, you must press SET for at least 3 seconds to definitively save the new settings. If no button is pressed for 60 seconds, the device will exit without saving (timeout). Installation manual - Tempatron Supports standard Carel NTC (10 kΩ at 25

Avoid installing probe cables near contactors or circuit breakers. If extension is needed, use cables with a minimum cross-section of 0.5 mm² .

Typically features two control zones (relay outputs) for managing multiple regulation stages, such as a compressor and an alarm or a heater and a fan. If the compressor or fan icons are blinking,

Monitors and controls temperatures from -50 °C to +150 °C .

The is a microprocessor-based electronic controller designed specifically for heating and cooling applications. Part of a series developed to replace or enhance the IR32 Universal range, this "plug-in" relay controller offers a simplified user interface with high precision for temperature management.