Chipblaster Jv10 Manual ~repack~ May 2026

Turn the adjustment bolt with an Allen wrench while monitoring the front pressure gauge until the target PSI is reached.

Verify that the 3-phase power is fully on and the CNC control's M-code signal is active. Check the tank levels; the return pump will not run if the fluid level is too low. chipblaster jv10 manual

High-pitched whining typically points to air trapped inside the filter housings or pump cavitation. Perform the full air purge sequence to clear the line. Turn the adjustment bolt with an Allen wrench

Pleated filter cartridges trap particulate matter down to 10 microns. A crossover valve setup allows operators to swap clogged filters while the unit remains fully operational. High-pitched whining typically points to air trapped inside

+--------------------------+-----------------------+------------------------------------------+ | Maintenance Task | Frequency | Purpose | +--------------------------+-----------------------+------------------------------------------+ | Check Filter Gauges | Daily | Monitor for pressure differential drops | | Purge Air via Petcocks | After filter change | Prevent pump cavitation & dry-running | | Clean Sump and Tank | Bi-Annually | Eliminate sludge and debris buildup | | Check Line Hose Wear | Monthly | Prevent dangerous line ruptures | +--------------------------+-----------------------+------------------------------------------+ Troubleshooting Faults

Understanding how the internal parts interact ensures safe operation and simplifies maintenance: