Crawford Cdm9 950 Installation Manual May 2026

: Turn the installation switch ( SW1 ) to the ON position. Calibration : Mark a "1m position" on the door frame.

: Standard CDM9 supports doors up to 400 kg; the HD version handles up to 800 kg. Supply Voltage : 230V AC, single phase, 50/60Hz. Operating Temperature : -20°C to +55°C. Mechanical Installation Steps

: Disengage the door and position it approximately 1.5 meters above the floor before engaging the operator again. crawford cdm9 950 installation manual

: Any fault in the safety edge will force the door into "Hold-to-run" mode for closing as a safety precaution.

The ECS 950 control unit uses several internal cards, including the (standard functions) and the manoeuvring card , which features status LEDs for the stop circuit and limit switches. : Turn the installation switch ( SW1 ) to the ON position

Squeeze the rubber safety edge firmly and release; the status LEDs (D4 and D5) should switch off briefly to confirm detection.

: If major repairs are needed for the electro-motor, sliding clutch, or main relays, official documentation often recommends replacing the complete operator to meet modern safety standards. Supply Voltage : 230V AC, single phase, 50/60Hz

Are you currently seeing a specific on the ECS 950 display, or are you performing a first-time setup ? 19146212.s21i.faiusr.comhttps://19146212.s21i.faiusr.com

: Turn the installation switch ( SW1 ) to the ON position. Calibration : Mark a "1m position" on the door frame.

: Standard CDM9 supports doors up to 400 kg; the HD version handles up to 800 kg. Supply Voltage : 230V AC, single phase, 50/60Hz. Operating Temperature : -20°C to +55°C. Mechanical Installation Steps

: Disengage the door and position it approximately 1.5 meters above the floor before engaging the operator again.

: Any fault in the safety edge will force the door into "Hold-to-run" mode for closing as a safety precaution.

The ECS 950 control unit uses several internal cards, including the (standard functions) and the manoeuvring card , which features status LEDs for the stop circuit and limit switches.

Squeeze the rubber safety edge firmly and release; the status LEDs (D4 and D5) should switch off briefly to confirm detection.

: If major repairs are needed for the electro-motor, sliding clutch, or main relays, official documentation often recommends replacing the complete operator to meet modern safety standards.

Are you currently seeing a specific on the ECS 950 display, or are you performing a first-time setup ? 19146212.s21i.faiusr.comhttps://19146212.s21i.faiusr.com

Skip to content