Gemel Txshs: User Manual Free
Press to deactivate the system. The indicators will flash once to confirm. Synchronization Procedure
Insert the new battery, ensuring it does not touch other electrical components. The LED should light up once the battery is in place. Gemel Txshs User Manual
The turn indicators will flash three times, and the alarm tone will sound three times to confirm the motion sensor is off. Press to deactivate the system
To activate the anti-theft function, press once. The following sequence occurs: Turn indicators flash twice. An alarm tone sounds twice (if programmed). The LED should light up once the battery is in place
Remove the screws on the back of the case and separate the two halves. Carefully remove the old battery.
Perform the described above to reconnect the remote to the bike. Troubleshooting
If you arm the alarm more than one minute after turning off the ignition, you must hold Button 1 for longer than one second. If the bike is left deactivated for over an hour, the system may shut down to save battery; in this case, cycle the ignition to wake it up. Deactivating the Motion Sensor
