Jby6201 Manual ❲Edge VERIFIED❳

Slowly turn the pressure knob clockwise. Test the spray pattern on a piece of cardboard. If you see "tails" (heavy lines on the top and bottom of the fan), increase the pressure until the pattern is even.

Failure to clean the JBY6201 immediately after use is the most common cause of pump failure.

Check for a clogged inlet strainer or a stuck intake ball valve. Tap the intake valve lightly with a wrench to loosen dried paint. jby6201 manual

Remove and clean the manifold filter (inside the machine) and the gun filter (inside the handle).

Before cleaning or servicing, turn off the power, switch to PRIME mode, and pull the gun trigger to bleed off any remaining internal pressure. Slowly turn the pressure knob clockwise

Usually supports up to a 0.017" or 0.019" tip. 2. Initial Setup & Priming

Below is a comprehensive guide to the setup, operation, and maintenance of the JBY6201, based on standard industrial operating procedures for this model. 1. Technical Specifications Failure to clean the JBY6201 immediately after use

Submerge the suction tube into a bucket of water or mineral spirits. Place the smaller return tube in a waste bucket. Turn the power switch ON .

Increase pressure slightly until fluid flows steadily out of the return tube. This clears the pump. 3. Operation: Switching to Spray Mode

If storing for more than 48 hours, run a "Pump Armor" or light oil through the system to prevent the internal valves from rusting or sticking. 6. Troubleshooting Common Issues