Connect the alternator output phases so the controller knows when the generator has reached the correct voltage and frequency. Control Outputs: Start: Connects to the starter motor relay. Fuel: Connects to the fuel stop-solenoid.
The back of the RGAM 12 features a series of screw terminals. Accurate wiring is critical to prevent damaging the controller or the generator’s alternator. Basic Terminal Mapping: lovato 31 rgam 12 user manual
Verify the fuse on the DC supply line and check that the battery voltage is at least 10.5V. Connect the alternator output phases so the controller
The time the controller waits after a power failure before starting the engine (to avoid "nuisance starts" during momentary flickers). The back of the RGAM 12 features a series of screw terminals
Connect to the 12V battery. Ensure correct polarity (Terminal 1 is usually negative/ground).
Before wiring the device, ensure your system matches these electrical requirements:
Initiates the engine crank cycle upon power failure.