Run the executable setup file with administrative privileges.
⚠️ Do not execute overrides or commissioning sequences without verifying the physical status of the HVAC equipment.
Once the software is successfully linked to the controller, technicians utilize specific commands to execute commissioning workflows. Task Category WCIS Operational Command / Step Expected System Result Select Point Log from the CLI/Menu. Displays all active hardware inputs and outputs. Override Points Select specific point, enter Override , and apply new value. Forces a damper or valve to a desired position for testing. Calibration Navigate to Calibration menu and enter measured airflow. siemens wcis manual
Editing device parameters to match specific mechanical designs. 💻 System Installation and Prerequisites
Navigate to the official Siemens Software Center or use the Siemens firmware installation package. Run the executable setup file with administrative privileges
Follow the installation wizard to deploy both the driver package and the interface software.
WCIS is typically bundled with the Siemens Launch Pad Installer. If installed alongside Launch Pad, a quick-access shortcut is automatically generated in the Launch Pad workspace. Task Category WCIS Operational Command / Step Expected
To install and operate WCIS correctly, ensure that the following baseline environmental conditions are met: System Requirements Windows 10 or later.
Setting up newly installed terminal controllers.