V2000-c Rfid Access Control User Manual Updated | Edge TRUSTED |

The V2000-C is a single-door multifunction standalone access controller. It supports up to and allows access via RFID card, a 4-to-6 digit PIN, or a combination of both. Operating Voltage: DC 12V ± 10% User Capacity: 2,500 Card Reading Distance: 3–6 cm Active Current: Lock Output Load: Max 3A Operating Temperature: -45°C ~ 60°C 2. Installation and Wiring

Enter a unique User ID (1-2500) + # + [4-6 digit PIN] + # . Press * to exit. Deleting Users Enter Programming Mode. Press 2 . By Card: Swipe the card you wish to delete. By ID: Enter the User ID + # . Press * to exit. 5. Advanced Settings Door Relay Time

Always change the default Master Code immediately after installation to prevent unauthorized access to your programming settings. V2000-c Rfid Access Control User Manual

Press * + 999999 + # . (The indicator light will turn orange/flashing). Exit Programming Mode: Press * .

Before mounting, ensure the power is disconnected. The rear of the unit features a color-coded wiring harness. Description Positive Power Supply Black Negative Power Supply Blue Normally Open (Electronic Lock) Purple Common Terminal Orange Normally Closed (Magnetic Lock) Yellow Exit Button Input Pink Doorbell Interface 3. Programming Basics The V2000-C is a single-door multifunction standalone access

To enter programming mode, you must use the . The factory default Master Code is 999999 .

Verify the input voltage is a steady 12V DC. Installation and Wiring Enter a unique User ID

Enter programming mode, then press 0 + [New 6-digit Code] + # + [Repeat New Code] + # . 4. User Management Adding Users (Card or PIN) Enter Programming Mode. Press 1 . For Card: Swipe the RFID card.

V2000-C RFID Access Control User Manual: A Comprehensive Guide